1 HP Variable speed motor and controller

$1,465.00$1,502.00

This 1 hp motor with variable speed controller is used in Beaumont’s Horizontal Disk Grinder, Vertical Disk Grinder, and EF-48 Horizontal Edge Finishing Belt Grinder.

  • 1 hp
  • 3 Phase  totally enclosed fan cooled (TEFC) motor
  • 1725 RPM
  • 5/8″ shaft
  • VFD controllers accepts either single phase 115 volt power or single phase 230 volt power, and delivers 3 phase 230 volt power to the motor
  • VFD will run on GFCI protected circuits, and includes four internally selectable GFCI sensitivity settings for improved performance
  • VFD has internal selectable frequency doubler to enable motor operation from 0 – 1725 RPM or 0 – 3450 RPM.
  • Optional 9480 Forward Reverse Switch

 

This 1 horsepower (1hp) motor with variable speed controller is used in Beaumont’s Horizontal Disk Grinder, Vertical Disk Grinder, and EF-48 Horizontal Edge Finishing Belt Grinder.

  • 1 hp motor
  • 3 phase / 60 HZ
  • 1725 RPM
  • 5/8″ shaft
  • 1 hp VFD NEMA-4X / IP-65 rated for complete dust-tight,  water-splashing, and light waterjet protection during operation
  • VFD accepts either 115 volt single phase power or 230 volt single phase power.
  • Standard NEMA 56C frame, with feet, for either face mounting or place/base mounting.  Motor mounting hardware not included.

Includes motor, VFD controller, on/off switch module, steel mounting bracket for VFD, cable from motor to controller, 1/4-20 screws with nuts to mount VFD to bracket, 5/16 x 3/4 hex screws to attach mounting bracket to bench or subplate (subplate not included), cable glands and wire connectors.

Does not include power cord, base plate or 9″ aluminum disk, each of which can be purchased separately.

Set up instructions for variable speed motor and controller.

You may also like…