2 HP Variable speed motor and controller

$1,685.00

This 2 hp motor with variable speed controller is used in Beaumont’s classic KMG 2×72 belt grinders / sanders.

  • 2 hp motor NEMA 56H foot mount
  • 3 phase totally enclosed fan cooled (TEFC) motor
  • 3450 RPM
  • 5/8″ shaft
  • VFD controller accepts either single phase 115 volt power or single phase 230 volt power, and delivers 3 phase 230 volt power to the motor.
  • When running on 110V, it will produce 1.5 hp.   When running on 220V, it will produce the full 2 hp.
  • VFD will run on GFCI protected circuits, and includes four internally selectable GFCI sensitivity settings for improved performance.

 

SKU: VS-VFD20 Categories: , , ,

This 2 horsepower (2hp) motor with variable speed controller is used in Beaumont’s classic KMG 2×72 belt grinder / sander.

    • 2 hp motor
    • 3 phase / 60 HZ
    • 3450 RPM
    • 5/8″ shaft
    • 2 HP VFD NEMA-4X /IP-65 rated for complete dust-tight, water-splashing, and light waterjet protection during operation.
    • VFD controller accepts either 115 volt single phase power or 230 volt single phase power
    • When running on 115V, it will produce 1.5 hp.  When running on 230V, it will produce the full 2 hp.
    • Standard NEMA 56H frame with feet for base mounting. For a face-mount 2hp motor and controller click here. Motor mounting hardware not included.

Includes motor, VFD controller, on/off switch module, steel mounting bracket for VFD, cable from motor to controller, 1/4-20 screws with nuts to attach VFD to mounting bracket, 5/16 x 3/4 hex screws to attach mounting bracket to bench or subplate (subplate not included), cable glands and wire connectors.

Does not include power cord, or subplate / base plate. Click here for a 115 volt power cord. Click here for a 230 volt power cord.

Set Up instructions for variable speed motor and controller

 

 

You may also like…